What are the details and precautions when using a fully automatic coaxial wire stripping machine

The fully automatic coaxial wire stripping machine can cut according to the specified length, and the two ends can be divided into 5 layers for wire stripping. This machine is equipped with two high-precision rotating blade heads, which can simultaneously strip the wire head and wire tail. Its technology is internationally leading and its speed is higher than similar products.

1、 Details of using a fully automatic coaxial wire stripping machine

According to the process documents, it is required to adjust the cable stripping length and core wire stripping length, adjust the up and down (left and right) cutting positions, check whether the compressed air supply is normal, adjust the air flow of the cylinder, plug in the power supply, and control the equipment operation with the foot switch.

2. After cutting a few pieces, check the length of the product and the quality of the core wire to ensure compliance with the process documents. After checking that the product is qualified, connect the power supply normally and continue production.

When stripping the wire, hands should not enter the inside of the protective cover to avoid injury to the machine.

4. When stopping midway, please unplug the power plug and let people leave. The machine will be powered off to prevent others from accidentally stepping on the foot switch and causing injury.

If it is necessary to replace the wire stripping blade, the power and gas must be cut off before replacement.

2、 Precautions for operating the fully automatic coaxial wire stripping machine

The operator of the fully automatic coaxial wire stripping machine must receive guidance and training from professional personnel before operating. Operators should be familiar with the general performance and structure of the machine, and master the prevention, judgment, and emergency measures for equipment failures.

When leaving the machine during the production process, the machine should be paused before leaving.

3. When the machine is running, do not place your fingers near the tool holder and chuck to avoid injury.

4. When a malfunction occurs, the machine should be stopped immediately; When there is a short circuit, smoke, or leakage in the circuit, the power supply should be cut off and the fault should be eliminated before starting up. The equipment must not operate under overload with faults.

Thank you for your patient reading. The above is an introduction to the details and precautions when using the fully automatic coaxial wire stripping machine. Some of the content is from the internet and is for reference only. If you would like to learn more about the detailed information of the fully automatic coaxial wire stripping machine, please feel free to call us for further inquiry. We will be dedicated to serving you.